Flat iron straightening cutting machine / flat wire cutting machine: This machine has two pairs of pressure rollers of different diameters are available for use when adjusting reinforced, pressure roller for the four-slot groove as with outside pressure roller washer on the outside, as with inside grooves, to the gasket mounted on the back press roller or the pressure roller to the pressure roller rolls over. Feed before turning the handle 4 Figure III dashed position, this time to lift the roller, the pressure roller spices were introduced between the front and then reversed the handle 4, and then be transferred according to the size of the bar diameter, tighten or loosen the handwheel 6 to change the pressing force between the rolls. Rod Wire Straightening and Cutting Machine generally require clamping force between the two rounds to be able to ensure the smooth steel is pulled, the invisible material has obvious rotation, and instant cut, reinforced significantly between the pressure roller slip phenomenon is appropriate. 11, the upper and lower cutter knife gap adjustment is on the front side is not loaded machine tool table 3 is mounted on the turret 2, mounted on the body under the knife, knife and hammer in the role of up and down movement and fixed under the knife to achieve reinforced cut adjustable rotary cutter twice in the next gap, generally ensure that the two are very close to the blade, and the cutter movement time and without resistance, after moving to tighten the lock under the knife cut knife locking nut 12, to adjust the order of the rack and use: 1 flat iron straightening cutting machine / flat wire cutter bar diameter is determined based on the width of the trough, a large bar diameter, it will loosen the screws a move lower corner panels 5 to the left, increasing the width of the trough, and vice versa small, generally large diameter steel trough width than 15-20%. 2 4 supination support columns into the upper corner panels, reinforced by being inserted into the trough tune, vertical sliding along the trough, to be able to feel the resistance, but also reinforced by steel bars from the trough in the test tone from left to right continuous extrusion is appropriate, or re-tune, and then the nut. 3 length steel plate at the desired location on the length, if supported by columns or hinder the installation length rod prop block board, temporarily removed. 4 length cut on the spring rod to the pressure to be applied to ensure reliable knife bounced back side prevail, while the crude material using three springs of fine material with one or both, to the lack of pressure can cause even cut to the excessive pressure that may occur when cutting was the top bend, strain or pressure roller over steel. 5. Beginning of each section of the disc material is often not straight into the trough, easy to get stuck, so the application manually agency cut and removed from the chute. The end of each section of the disk material is fed to a high degree of attention to the slow tune straight best to prevent photorefractive wounding. Wu Xin County welded flat iron straightening cutting machine / flat wire cutting machine. http://www.zxhjsb.com